2001 Ford Taurus Check Engine Light?
(2010-05-30 16:25:29) 1. Says: Ok so my Taurus broke down about a year ago, and it just got done being fixed (my dad fixed it so it took some time)Well now the check engine light is on and the car didn't pass the smog because of too much emission at 15MPH.
My question is, could this be anything or could this be related to the smog/emission?
It also has very old gas in it. Could that be the problem instead?2. Says: If you're performing this procedure in an effort to pass an emissions test when the check engine light or service engine soon light is on or illuminated, read on and in detail to learn how the check engine light reset procedure works.
You may have already read information describing how to turn off the check engine light or service engine soon light prior to the emissions test in order to evade the smog inspection. By turning off the check engine or service engine soon light, in actuality deleting all emissions data from your vehicle, the smog machine will not know your vehicle has or has had emissions faults.
This method will NOT work. We will describe the reset or "turn light off" procedure so you may understand the OBDII emissions testing process and how the check engine light or service engine soon light apply to the emissions test.
Perform procedure at your own risk!
Step 1. Locate your vehicle's battery. Disconnect the 12v positive cable (red wire) from battery terminal (+). Leave it disconnect for 5 minutes. While the battery is disconnected, cycle the ignition switch to ON position 3 times.
You've just erased important emissions related data which is invaluable to a smog technician attempting to repair your vehicle.
You also deleted very important "readiness flag" data which takes days, if not weeks to compile.
Step 2. Insure ignition switch is OFF. Reconnect the battery 12v positive cable (red wire) to battery terminal (+).
You're risking electronic component damage. High voltage spark produced during the reconnection of the positive 12v cable can cause damage to fragile electronic emissions component/s.
Step 3. Cycle ignition switch to ON position and wait 1 minute, then start your vehicle. Check Engine Light or Service Engine Soon Light should be reset and turned OFF.
If you are successful in turning off the check engine light, this means your vehicle has not stored it's emissions data in the ROM section of it's computer and you have just deleted all data pertaining to your vehicle's engine and emissions systems, probably including your radio & system settings.
Step 4. Drive your vehicle for one week under normal driving conditions. During this period the emissions computer is gathering data and re-learning your vehicle's emissions components and systems. The emissions computer OBDII (on-board diagnostics) system must complete at least one drive cycle (in some cases two or three). A drive cycle is a sequence of internal tests which the emissions computer runs while your vehicle is being driven. This insures all emissions systems are functioning properly. Proper "readiness flags" are set as the computer completes it's cycles. Test cycles are unique to a vehicle. Certain cycles run under very strict parameters, and may require extended driving time to trigger on. Cycle data and readiness flag information is available through your dealership's service department. The data vary widely.
During your drive, maybe even as soon as you start the engine, your vehicle realizes an emissions fault, and turns on the Check Engine or Service Engine Soon light.
Emissions computer refuses to set a required readiness flag. No check engine light, but no chance of passing the emissions test either. However, you will not know this until your vehicle is smog tested. If the particular emissions test center doesn't offer a free re-test, you forfeit your inspection fee.
Step 5. Take the smog test. Important Note! Your vehicle might not be completely ready for the smog check inspection. Required parameters may have not been set by the emissions computer.
Your vehicle might not be ready for the emissions test. There will be no way of knowing this until the smog test is complete. Your normal driving pattern (if not for an extended length of time) may have failed to trigger the emissions computer tests needed to set the required readiness flags.
Passing the Emissions Test - What are my chances of passing the emissions test after resetting the emissions computer and turning off the service engine soon light or check engine light?
A slight chance of passing the emissions test after a reset does exist, but it is very slim. The trick is to get your vehicle smog checked before your engine computer detects the check engine light illuminating trouble code, and only after the required readiness flags have set. The chances of the engine computer setting the required readiness flags before detecting the trouble code and illuminating the check engine light are slim to none. And so our opinion... time is better spent finding a reputable smog check repair station to diagnose the check engine or service engine soon light, then time spent trying to avoid detection and/or repairs.
Even after evading check engine trouble detection, passing the emissions test will require your vehicle's exhaust sample, which will be collected by the smog machine, fall within California Air Resource Board specifications, a3. Says: Possibly due to old fuel; if you want to hassle with draining the tank and replacing the fuel filters ( there may be more than one ).......have you had an OBD scanner on this vehicle to see what codes show ?? That would be a good starting point4. Says: Old gas turns into a gummy substance that can completely ruin your engine. The Tank should be drained and a petrol based cleaner should be applied to a clean tank of gasoline.
As far as the smog/emission.. try driving it with the clean gas for a good run on the highway.. park and turn it off over night, and check the next day to see if the light goes on. If it does the gummy gas might have ruined the Emission systems and they will probably have to be replaced, namely the EGR.
Hope this helps and good luck with the car!5. Says: Yes it would have something to do with the light being on. The check engine light only comes on when your vehicle has an emissions related problem. I would not bet on old gas being the problem, but literally hundreds of things could have made it come on. Your best bet is to take to a reputable auto repair shop (not a parts store. Those guy are idiots and have no idea what they are doing) and pay them to look at it. Tag: 2001 Ford Taurus Check Engine Light?