Gas is not getting through injector on 6.5 engine swap, '95 chevrolet pickup?

(2011-04-18 14:20:45)

1. Jonna Pierce Says: Swapped out the old engine, replaced practically everything else. It turns over like a charm, but fuel is not getting through the injector. I've tried to start it 15-20 times so far. Any suggestions? Thanks!

2. nightprowler Says: WOW that sounds like a big project,did you use the computors from the 6.5 engine?I think you will have to switch them for sure....good luck

3. P W Says: if it didn't start the 1st time its not going to start the 200th time you try, until you change something. No suggestions because you just did engine swap you had every wire and hose disconnected, don't know if you did simple same for same swap or put engine from a 2005 truck into your 1995 truck thinking it would just work (it won't). All i know is you just swapped engines and now truck doesn't crank. Sorry to hear that nothing i can do for you there are about 2000 places this could be coming from.

4. The Brain Says: Are you saying there is no fuel coming out of the injectors?

Is the fuel pump connected? Is the fuel pump fuse installed? Did he prime the fuel lines?

Are all of the electrical wires connected? Are the vacuum hoses new and installed properly?

5. Onnied Says: if the engine you put in has been setting awhile,well I hate to tell you this you'll have to replace all the injectors,their stuck happens every time be safe my friend